1、根據需要電纜接頭的型號規格選購合適的接頭材料，如今電纜線回收材料質量也是參差不齊，但是為了確保電纜接頭質量，建議不要貪圖便宜，選擇質量信得過的電纜接頭廠家的材料。 2、電纜接頭時不要選擇雨天，因為電纜進水會嚴重影響電纜的使用壽命，嚴重的甚至會出現短路事故。 3、電纜線回收前一定要仔細閱讀廠家的產品說明書，這一點對于10kV及以上電纜，尤為重要，做之前把所有的工序都想好再做。 4、10kV以上單芯鎧裝電纜的終端接頭，切記只能一端鋼帶接地。 5、銅管壓制時不能太用力，只要壓接到位即可，壓接后的銅端面勢必會有很多凸起點，這個一定要用銼刀挫平，不能留有任何毛刺。 1. According to the type and specification of the cable connector, the quality of the cable recovery materials is also uneven, but in order to ensure the quality of the cable joint, it is suggested that the material of the cable joint manufacturer, which is reliable, should not be greed and cheap. 2, do not choose rainy days when cable joints are connected, because the water intake of cables will seriously affect the service life of cables, and even serious short-circuit accidents will occur. 3, before the cable recovery must carefully read the manufacturer's product instructions, this point for 10kV and above the cable, especially important, before doing all the process to do well again. 4. Terminal joint of single core armored cable above 10kV, remember that only one end of the steel strip is grounded. 5, copper tube pressing can not be too hard, as long as the pressing in place, the copper end after the pressure will have a lot of convex starting point, this must be flattened with a file, can not leave any burr.