電纜線路是保護電纜線的重要線路，對于電纜線路我們需要經常的去檢查與排除，下面就為大家介紹它的檢查方式。 The cable line is an important line to protect the cable line, we need to check and eliminate the cables frequently, and we will introduce the inspection method. 如果電纜線遭受到機械損傷，最主要的原因可能就是受到外力破壞或安裝不慎以及不可違抗的自然破壞等，遇到這種情況，就要采取妥善的修繕措施。如果電纜線的絕緣受潮，可能的原因有：①接頭盒、終端盒密封不嚴，應割去受潮段電纜，重新安裝中間接頭盒或終端盒。②檢查是否由于制造不良、外物刺穿、護套有小孔或裂紋造成的，應檢查導體中有無水分，采取相應干燥處理措施。 If the cables subjected to mechanical damage, the main reason is probably by external damage or careless installation and shall not disobey the natural damage, encounter this kind of situation, will be properly repair measures. If the cable is insulated with moisture, the possible reason is that the connector box and the terminal box are not tightly sealed and should be cut off to the dampness section cable and reinstall the intermediate connector box or terminal box. Check whether the water in the conductor should be checked for moisture in the conductor, and the corresponding dry treatment measures should be taken. 如果出現終端頭浸水爆炸的事故，應加強維護，做好防積水措施。如果發現電纜線出現了短路或斷路事故，最主要的原因就是可能遭受到了外界機械損傷。如果發現電纜線中間接頭發生爆炸，可能的原因有：①電纜過載引起接頭盒內絕緣膠膨脹。②導體本身連接不良。③封鉛漏水。 If there is an explosion in the end of the head, it should be strengthened and maintained. If the cable is found to be short-circuited or broken, the main reason is the possibility of external mechanical damage. If there is an explosion in the middle of the cable, the possible reason is that the cable overload causes the insulation to expand in the connector box. The conductor itself is not connected. The lead is leaking.